Aufsatz in einer Fachzeitschrift
Flexural strength of PVD coated float glass for architectural applications
Details zur Publikation
Autor(inn)en: | Meszaros, R.; Wild, M.; Merle, B.; Wondraczek, L. |
Verlag: | SOC GLASS TECHNOLOGY |
Publikationsjahr: | 2011 |
Zeitschrift: | Glass Technology - European Journal of Glass Science and Technology Part A |
Seitenbereich: | 190-196 |
Jahrgang/Band : | 52 |
Heftnummer: | 6 |
Erste Seite: | 190 |
Letzte Seite: | 196 |
Seitenumfang: | 7 |
ISSN: | 1753-3546 |
eISSN: | 1753-3554 |
Zusammenfassung, Abstract
The effect of PVD coatings on the ring-on-ring flexural strength of soda lime silica float glass was studied. A 70% increase from 280 +/- 8 to 478 +/- 10 MPa was observed on the air-side of the glass after applying a multilayer low emissivity coating of 100 nm total thickness. A similar but less pronounced effect could be obtained with a TiO(2) single layer of 50 nm. At the same time, for both coatings, the Weibull modulus was found to approximately double. Results are interpreted on the basis of two assumptions: initial defects on the glass surface are covered by the coating, and their growth is prevented due to the protective function of the coating, especially as a humidity barrier. Both assumptions were confirmed by atomic force microscopy and micromechanical analyses. This barrier function leads to significantly improved resistance to long term fatigue and stress corrosion, respectively.
The effect of PVD coatings on the ring-on-ring flexural strength of soda lime silica float glass was studied. A 70% increase from 280 +/- 8 to 478 +/- 10 MPa was observed on the air-side of the glass after applying a multilayer low emissivity coating of 100 nm total thickness. A similar but less pronounced effect could be obtained with a TiO(2) single layer of 50 nm. At the same time, for both coatings, the Weibull modulus was found to approximately double. Results are interpreted on the basis of two assumptions: initial defects on the glass surface are covered by the coating, and their growth is prevented due to the protective function of the coating, especially as a humidity barrier. Both assumptions were confirmed by atomic force microscopy and micromechanical analyses. This barrier function leads to significantly improved resistance to long term fatigue and stress corrosion, respectively.
